Matweb

We produce ASTM/ASME Grade 304, Grade 304L,304h, 316, 316L, 316H, 316TI, 321, 321H, 309S, 309H, 310S, 310H, 410S, 2205, 904L, 2507, 254, gh3030, 625, 253MA, S30815, 317L, Type 317, 316lN, 8020, 800, 800H, C276, S32304 and others special requirement stainless steel grade.

The austenitic structure also provides these grades excellent toughness, even right down to cryogenic temperatures.

316 is taken into account proof against potable water with as much as about 1000mg/L chlorides at ambient temperatures, lowering to about 500mg/L at 60ºC. It has good oxidation resistance in intermittent service to 870ºC and in continuous service to 925ºC.

The composition proportion includes a observe B that reflects the value is the utmost except in any other case indicated. This would counsel that any copper is out of specification for ASTM A 312 type 316L. See comments on this and another publish about ASTM A 941, Steel Alloy Terminology. On request we can produce materials with a tensile power of over a thousand MPa .

Click here to view all the property values for this datasheet as they were originally entered into MatWeb. I am unsure of this, but the copper presence might be a problem for corrosion resistance, as copper is extra active, from a galvanic point of view, than SS 316L . Therefore, A4-80 is an austenitic, acid proof stainless grade (normally 316 materials – 316 or 316L) which has been chilly worked to supply a minimal tensile power of 800N/mm² . Results are displayed up to a maximum of 200 materials per page. Follow the hyperlinks below to view complete property data.

• The supplied values tend toward the conservative end of the spectrum and could be used as baseline design values for preliminary design.
• Alloy 316/316L is molybdenum-bearing austenitic chrome steel.
• The material property data supplied are supposed to be consultant of the fabric described.
• 1.4435 / AISI 316 L is an austenitic chromium-nickel-molybdenum stainless-steel with low carbon content material.

Our stainless production range

Brand��Chanson,TISCO,BAOSTEEL,POSCO,JISCO,LISCO

Cold working produces enhanced levels of tensile strength. All austenitic chrome steel fasteners are usually non-magnetic within the annealed situation.

We have thousands tons stock of stainless steel sheet and coil with various size and grade,mainly include austenitic stainless steel, martens stainless steel (including precipitation hardened stainless steel sheet & coil), ferritic stainless steel, and duplex stainless steel.

Characteristics of Stainless Steel Sheet and Plate:
High corrosion resistance
High strength
High toughness and impact resistance
Temperature resistance
High workability, including machining, stamping, fabricating and welding
Smooth surface finish that can be easily clean

flexible stainless steel fuel line

Similar to Type 316 for superior corrosion resistance, but in addition has superior resistance to intergranular corrosion following welding or stress relieving. Good corrosion resistance to most chemical compounds, salts, and acids and molybdenum content helps resistance to marine environments. The low carbon content material of 316L reduces the possibility of in vivo corrosion for medical implant use. 316L has fabrication characteristics much like Types 302 and 304.

Continuous use of 316 within the ºC vary isn’t really helpful if subsequent aqueous corrosion resistance is important. Grade 316L is extra immune to carbide precipitation and can be utilized in the above temperature range. Grade 316H has higher strength at elevated temperatures and is sometimes used for structural and pressure-containing purposes at temperatures above about 500ºC.